Looks like you access from European region.
Would you shop at webike.eu.com?
SIP Scootershop
SIP SPAREPARTS Spacer Cylinder Head for 73cc / 74.6cc Cylinder (th) 0.5mm
Product # 90755100
(0 reviews)- New
9.57 USD (1,525 JPY)
Webike Point: +15 pt
(0.09 USD)
Delivery Information
No inventory Information Acquired.
In order to place an order, please estimate from below.
Product detail
Diameter 47.4 mm
Aluminium
TUNING RACE - for professionals
** If an instruction manual is included, it will be in a foreign language.
* As this is an imported product, delivery may be delayed. Thank you for your understanding.
* Images may include other products.
* Product specifications may be subject to change due to manufacturer circumstances. Thank you for your understanding..
Push it to the limit - Spacer Cylinder Head and base for long stroke shaft tuning.
Thicker base and head gaskets/spacers are required for higher-set Cylinders and Crankshafts with extended stroke.
Available as Gasket Cylinder Head or Cylinder Base.
Available in thicknesses of 0.5 mm / 0.8 mm / 1.0 mm.
Adapted for the various cylinder sizes.
When using a Long Stroke Crankshaft, half the length of the extra stroke must be compensated for by a head and/or base gasket.
When compensating with a foot seal, the outlet times are longer and the overflow times are significantly longer.
If the outlet is also raised slightly by milling, the Engine is optimized for higher speeds.
Compensation with a head gasket extends the exhaust and overflow times only slightly, whereby the overflow time changes more than the exhaust time (less pre-discharge).
This is an optimization for more torque at medium engine speeds.
If, for example, you install a Cylinder with a 46 mm stroke Crankshaft instead of the original 43 mm stroke, the 3 mm more stroke must be leveled by a 1.5 mm Gasket.
Then the following applies: 1.5 mm compensation base: wide rev range and high horsepower figures, but low torque and a late and sudden power boost.
1.5 mm compensation head: brute torque and risk of wheelie in the lower revs, but lower peak power.
The head gaskets are available in thicknesses of 0.5 mm / 0.8 mm / 1.0 mm / 1.5 mm, the base gaskets in thicknesses of 0.5 mm / 0.8 mm.
We offer various Cylinder Head Spacers with diameter 43 mm for Racing Cylinders around 63 ccm and Spacers with diameter 47.4 mm for all Racing Cylinders with 73-74.6 ccm.
The cylinder base spacers are available with diameter 46.0 mm for the 50-63 cc cylinders and with diameter 50.0 mm for the cylinders up to 73 cc.
Depending on the Cylinder, the base gasket should be individually adjusted to prevent it from lying over the overflow channels.
Conclusion: Long-stroke shaft tuning with different spacer combinations is one of the performance enhancements of recent years.
This is where the wheat is separated from the chaff.
Gaskets for the Cylinder Head and Gasket Cylinder Base can be combined depending on requirements.
Be sure to lubricate the Spacers with a little sealing paste before installation.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
New arrivals in used
New arrivals in used
Customer Reviews
There are no Customer Review yet.
Full Custom Build Inspiration
