Speedometer Cable

Cost performance is satisfactory because it can be purchased cheaper than OEM.
I am worried about durability because it is outside of OEM but it seems I ran around 400 kilometers in one month
I think that it is nothing like OEM.

Because the OEM's Meter cable was nearing end, I decided to exchange and thought it was not OEM Product here. For amateurs, I do not understand the difference with OEM Product, I think it is a good thing. I will check the difference in durability etc. from now

【What made you decide the purchase?】 Price and delivery time
【How was it actually used?】 I think there is no difference from OEM

【Was it difficult to install? (Hard parts case)】
it's simple

【Please tell me the point of installation and hang (in the case of Hard parts)】
You'd better remember how Cable was working

[Is there anything I was disappointed about?] None

【Hope for Manufacturer - Please let me know if there are any improvement points】 None

【Have you compared items?】 OEM

[Others] Periodically insert Wire grease. If you forget it will expire

I decided to purchased this speedometer cable because of the low price.The build quality almost same as the OEM cable and OEM cable just a little bit pricey than the NTB version.It's been 6years since I first change my bike's(TW200) speedometer cable.So Time Has come to change it.At some times when I was traveling at a speed of more than 80 km/h, I noticed that the needle on the speedometer bouncing back just a little bit.I want to replace the old speedometer cable because I got a brand new speedometer cable from WEBIKE SHOP. Before I remove the old speedometer cable ,First I had to remove the headlight plastic shell and unplug the wiring connector then removed the headlight lamp.SO it was very easy to reach the speedometer cable and unscrew from the speedometer .Then squeeze the speedometer clip/ Remove small clip at bottom of cable housing and free the old speedometer cable from the groove in the brake panel..Before I installed the new speedometer cable ,pull speedo cable out of housing and apply grease (I had tube of waterproof lithium grease handy) to cable as your feeding it back in housing. turn and wiggle it back in all the way.apply a light coat of waterproof grease to the speedometer O-ring ( Brand new speedometer cable doesn't have an O-ring).Install the Brand New speedometer cable into the brake drum and then install the speedometer cable clip into the groove in the brake panel.make sure clip in right by gently trying to pull housing back out.Then need to tighten the upper cable that goes direct to the speedometer itself. 10 minutes Job .After installing the new cable speedo needle has no bounce and steady as a rock on smooth roads.AS ALWAYS THE PACKAGE ARRIVED ON TIME FROM JAPAN AND VERY NICELY PACKED.THANKS FOR THE SUPPORT WEBIKE.Awesome Online Shop.If anyone need parts for your bike Webike Shop is the Best place.Reasonable Prices and 5Star Shop. Cheers !

[How is it used?
Used for HORNET250; Meter needle was shaking, so it was replaced at the same time as OEM Product's Joint.
How was your experience with it?
So far, it has been used without any noticeable drawbacks or problems.
How did it compare to other products?
I think we can say OEM Product same etc.
[Points to note]
When replacing the HORNET meter cable, it is necessary to remove the tank, so some knowledge and tools are required.