Filter Adapter

I bought this to add a power filter to my FCR Carburetor Body.
The price was cheap.
I didn't know which one was the best, but I decided to go with this one, which seems to have a lot of people buying it.
It's not a very visible part, so it's not a problem if the Power Filter is attached.)

Frequently Asked Items
What made you decide to buy?
The parts needed to make the FCR Carburetor Body37FunnelSpec. into a Power Filter conversion and were available at WEBIKE's Point.

How was your experience with it?
The rear of the engine looked hollow, but I think it was resolved.
Idling sound is good without any clogging.

Was the installation difficult?
Remove the seat and side cover and shift the tank. →Remove the Funnel→Install Adapter→Air Filter

【Please tell me the installation point and hang】
? When you remove the original Funnel and install the Adapter, you can use The short-bent hexagonal tool. is easier to use (made by 100 yen SHOP)
A part of it interferes with the side cover of the Right, but it is OK if you push it in.


[Was the Instruction Manual easy to understand?
No Instruction Manual

[Included Parts:were they on?
This product only
[Others]
Power Filter is a KOSO 55 Pi

important item
[Was there anything that disappointed you?
None
Do you have any wishes or improvements you would like to make for the Manufacturer?
Quantity by number of cylinders:I thought it was easier to buy the Set price sale.

[Do you have any products to compare it to?
None

MotorcycleParts adapters can be super expensive for a little something, but I think this is a reasonable price.
I don't know about the durability and accuracy of it since it's not yet in use, but it's made of reliable DNA, and I think it's a Large sturdy!

Air cleaner to FCR Carburetor Body Carburetor The Sponge type air filter is easy to use, but the Unless it is a monolithic molded product, the adhesive may peel off, disintegrate due to weathering or hydrolysis, blow back, or otherwise disintegrate There are issues such as flames caused by BackFireA

So far, I've been able to bring up the setting in the state of funnel once, and then air cleaner element and adjust the settings again, and then use Air I've changed to cleanerSpec
I'm pretty sure it's cheaper to use some OEM parts for the same air cleaner I think there was an Adapter, but I forgot about it, so I used this product instead I think that it is good because it is lightweight and cheap because it is not the Aluminum Cut-out for nothing

Remove the funnel and the air cleaner element can be installed directly into the CR It's a bit more complicated than Carburetor, but that's about it

FCR Carburetor Carburetor Body-MX41 & Phi; Installed on Off-Car Series
When installing on the FCR Carburetor Body-MX, Air Jet's outlet is the same as the normal Since it comes from the FCR Carburetor Body
It needs to be processed
That's why I chose this plastic one instead of the Aluminum Cut-out!
As a result Large was the right answer
I drilled a hole of about 8mm with Drill, but it was not so hard because it was easy to process It wasn't
Also, it's made of plastic, so it's inexpensive, and if I buy it and it doesn't work, I can give up on it

I was worried about whether the FCR Carburetor Body-MX would attach easily, but I was satisfied with the results available