Exhaust Muffler Gasket 2-Pack

About quality and texture: I am happy with the quality of the exhaust system gasket from Kitaco. A compressing gasket with an external diameter of 32mm and an internal diameter of 26mm.About the feeling of use: The exhaust system gasket is a firm fit and holds itself in place once positioned and has sealed the interface between the exhaust port and the exhaust pipe with zero air leaks.Products to buy together: Some replacement exhaust stud nuts would also be desirable to purchase along side exhaust system gasket as mine were cosmetically damaged from using an open end spanner due to the thickness of the exhaust pipe and not being able to use a socket.Difficulty of installation: The process to install took about 30 minutes, loosen the exhaust stud nuts so you can lower the exhaust pipe to access the exhaust port to replace the exhaust system gasket. The old exhaust system gasket was very tight and difficult to remove on this motorcycle and required the use of a small flat screwdriver to lever it up from the bottom edge and I would recommend using something softer as the screwdriver slightly maked up the exhaust port surface. Refit the exhaust stud nuts and tighten to 27N.m.Cost performance and comparison with other products: Good costing as you are getting two quality gaskets from Kitaco that are always in stock and ready to ship but the genuine Honda gasket is slightly cheaper but you have to wait a while for stock to be available.About shipping and packaging: Sea freight was my preferred method of shipping due to the lower cost but currently this service is unavailable from Japan Post, EMS is much faster which is nice. Webike kept me updated on the status of my order up to when it shipped. The parcel arrived within the expected date range and was well packaged with no chance of the part being damaged.Any concerns, cautions, or advice when purchasing: Kitaco or K-Pit offer many replacement gaskets for the Monkey 125 that can be viewed in the Kitaco engine tuning and maintenance parts catalog and stock is available and ready to ship here on Webike.

It was a little difficult to remove the NORMAL Gasket, but after 10 months of exhaust system replacement, I managed to get it off by prying it with a slotted screwdriver. When I took it off, I found that it was in a tattered and battered state.
It was the first time to replace the exhaust system, so I can't compare it with the normal basket, but it didn't stop on the exhaust system side, so I had to use my fingers while putting it on the exhaust pipe. Quantity:It's set. (I did this because I failed to apply Silicon grease with a dot, but there may have been a better way. Maybe there was a better way.)
After that, I drove about 100 miles and checked it again, and it was fine.

I used it to replace the exhaust system on my Monkey 125. It installed without any problems and no trouble.
It is made by a reputable manufacturer, so you can use it with confidence.

It is an old motorcycle, but it is just right for Repair Parts!

Compared to OEM Parts, the fitment is a little looser and requires more hang when installing the Engine and Chamber.
There are no exhaust leaks.
OEM PartsYou get two for the price of one.
It's a great way to save money on maintenance costs.
KITACO, Webike
Thank you.