Seat Cover for Re-covering

Completion will rise considerably depending on ingenuity.
☆ Four items are Waterproof - I thought it would be nice to have some more fabric thickness.
- Rain may penetrate from the seam → Seat thinly paint Silicon sealant on the entire back side, Seat Urethane foam is pre-rice bag etc etc. We put it in a heavy plastic bag of a Completely Waterproof.
Hardness when sitting is covered with Urethane foam Poly bag etc. etc. I am adjusting with.
Urethane foam leakage measures are necessary, but there is no problem at all other than doing it.
Because the fabric is soft, the feeling of mouth is quite good. Even if it is thin it does not matter for durability.
Personally I think that it may be a bit thicker.
Please fasten Tucker exactly while pulling it.
It is glossy than OEM, but it is not enough.

I purchased the Super Dio AF28 for the Super Dio AF28.
It stretches well and can be stretched neatly.
The quality is good enough.
However, unlike OEM, there are seams in each part, so this is a concern for water seepage.
Third-party products are probably all the same, so with that in mind, this is a good enough product.
Size feel is good.
The design, cutting, and sewing are both fit, sturdy, and good.
Since the product comes folded, the folds will be visible even if it is stretched at first.
However, it grew and disappeared over time.
Well and pulling and stretching seem to be important.
The cost performance is excellent because the price is reasonable and the quality is adequate.
I felt I could buy Repeat.

I've torn the Seat on my moped Scooter, so I'm thinking of putting a Cover on it that can be One-touch mounted with Rubber.
I thought about reupholstering it, but if I was going to do that, I wanted to reupholster it properly like a new car, so I bought a Kawi.

Tucker was easy because I was able to rent an Air tool (Air Tucker) and I have a Compressor at home.
Even if you don't have the equipment, you can use a HandTucker sold at Daiso for about 500 yen to do the job.
However, make sure you have a needle (core) with a short foot. I used a width of 10mm and a foot of 6mm.
The Tucker cores that often come with TuckerBody have long legs, and if you use them to reupholster your Seat, they will stick out on the surface, so please don't use them.

Please refer to youtube and other sites for more information on how to do this.
Decide before and after, Quantity:Pair (for Left and Right) Decide on ... and hit the Tucker while pulling on the diagonal.
If you cut the excess part at the end, the opening and closing of Helmet in (Seat) also becomes smooth.

The finish is much better than the so-called Rubber type Cover, and it feels good ~.
I'm glad I took the DIY challenge to reupholster the seat, because cracks and holes in the seat can cause rainwater to seep into clothes, which is uncomfortable.

Glue from the back of the Seat cover seam to protect the Seat Sponge from moisture. and installed on top of the Sponge covered with Polyethylene Seat. It was. You will need a strong Tucker to install it. It can be used normally.

The Seat was torn, so I replaced it with a new Seat The texture is so new
It slips when you sit down At first, I thought it was inevitable
Later, if you've never replaced a new Seat, you'd better get a motorcycle shop to do it for you!