Building parts themselves is good, but regrettable.
I purchased it for circuit running at YZF-R25. Work hardness, machining side of machining etc are also price only. However, the inner diameter of the pivot screw hole sleeve was too small. It is a story with a combination of a genuine master, pivot bolt and nut all new. After that, I also tried spare genuine master and bolts that I had in second hand, but in either case the holes are too tight to pull the lever back to normal position. Of course, if it is a genuine lever it can be installed without problems. I had a lot of hardships until I understood the cause, but in the end it was 0. It was possible to use it without trouble if we mounted the bolt outer diameter to about 2?. I do not know whether the tolerance of genuine parts made in Asia is large or whether the active accuracy is too good. However, as a consumer at the end, it is a part related to life, and I bought it thinking that quality can be expected even with painful expense. Depending on the situation it is a part that may be replaced in a hurry. Sometimes I can not reach the cause immediately. Because it is a car model exclusive item, I would like to ask for improvement.
View Detail
