![[Repair Parts] Blinker Position Harness R/L Set](http://st-img.webike-cdn.net/catalogue/images/34583/00-05-0160.jpg "[Repair Parts] Blinker Position Harness R/L Set")
![[Repair Parts] Blinker Position Harness R/L Set](https://st-img.webike-cdn.net/st/photo/impression/3b/3b670a0d08b0be7c90c0530063fbb3ecL_TM.jpg "[Repair Parts] Blinker Position Harness R/L Set")
![[Repair Parts] Blinker Position Harness R/L Set](http://st-img.webike-cdn.net/catalogue/images/34583/00-05-0160_s.jpg "[Repair Parts] Blinker Position Harness R/L Set")
![[Repair Parts] Blinker Position Harness R/L Set](https://st-img.webike-cdn.net/st/photo/impression/3b/3b670a0d08b0be7c90c0530063fbb3ecL_s.jpg "[Repair Parts] Blinker Position Harness R/L Set")
I thought it was expensive, but I guess I had no choice.
I used it to install a Corso Sequential Blinker with Position on a Type 3 Grom.
I think the 3PConnector is rectified by a diode and a resistor. The resistor is probably a 75Ω? (Simple Tester measurement) I'm not sure if the light intensity drops when the blinker is in position or not. I felt that there was no change in the appearance of the corso.
Wiring side is Quantity:Since it's 2pc, I think the sequential blinker from an external product will also function as Position. In the case of the above blinker, Position was lit and the blinker also flowed.
In my case, I had three Blinker lines, so I extended the PositionWiring from the license lamp and connected it.
Also, I had a lot of problems with the behavior of Corso's Sequential Blinker with Position, and it was a bit large.
I'll post more details in the Blinker Impressions.
![[Repair Parts] Blinker Position Harness R/L Set](https://st-img.webike-cdn.net/st/photo/impression/3b/3b670a0d08b0be7c90c0530063fbb3ecL_TL.jpg "[Repair Parts] Blinker Position Harness R/L Set")
![[Repair Parts] Blinker Position Harness R/L Set](http://st-img.webike-cdn.net/catalogue/images/34583/00-05-0160_TL.jpg "[Repair Parts] Blinker Position Harness R/L Set")