Bullet Terminal is a little too small.
The bullet terminal of the ACC power out is a little small, and the Male terminal of the same standard is hard to enter. As a result, I cut it off and reattached the Bullet Terminal.
View Detail
Looks like you access from European region.
Would you shop at webike.eu.com?
6.19 USD (986 JPY)
Delivery Information
In Stock : 1 left, Ships within 24 hours.
Estimated arrival date around
Z900RS
-FNO.ZR900C-052000
NINJAZX-10R
11-15
NINJAZX-10R
16
Z900RS-Cafe
-FNO.ZR900C-052000
Quantity: 1 pc.
[Specification]
・For taking out 12V power supply
・With Mark Tube (Kitaco Original)
**Do not use for connection of products with high power consumption and current (amplifier, compressor, etc.).
*CA / CB 103 (HONDA) female gibbons are used for the harness gibbons..
Easy!Accessory power out!
This is a harness that allows you to connect to the vehicle's coupler for accessory power.USB power supply and ETC power supply can be removed smartly.
Kitaco's original power supply label (Kitaco original mark tube) is attached to the lead wire for easy identification.
Extraction point: Diagnostic system connector
[installation instructions]
・Open the pillion seat and remove the 6-pin waterproof coupler cap from the connector cover.
・Connect the power supply harness to the removed waterproof coupler.Connect the USB power supply to ACC+ and GND-, and the work is finished.
■Options
K・CON BULLET TERMINAL SET (CA / CB 103 / HONDA) 0900-755-01000
(Male / female bullet terminals 5 each, male / female sleeves 5 each)
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.