Rearsets Kit

The Instruction Manual for installation is only Illustration? I think the Instruction Manual is a little confusing for those who only do routine maintenance on their motorcycles. I started with the Right Side first, but it took me a while to check the parts (number of bolts, length, etc.), and then I had to fine-tune the stop-lamp, so I had to install it, check it, adjust the rose, install it, and repeat the process about 4 times. The process was repeated 4 times to complete the installation. The weather was not so good after the installation, so I could not test drive the car, but when I put my foot on the footpeg, I could not feel any drastic change. After the installation, I cleaned and lubricated the chain and am looking forward to a sunny day.

I installed it myself

good point
When I stopped, the footpeg that was hitting my shin was now on my calf side.
I have the 45mm back setting, but I think the 57.5mm back will allow me to put my feet down without worrying about footpegs.
With the low Handlebar position on the Cafe, Rear Sets made the forward leaning posture more natural.
The texture and precision of the objects are high.

A bad point
The Instruction Manual is unfriendly.
Depending on your position, the Footpeg Bolt may interfere with the inside of the Footpeg, or the Side Stand bar may be too close to the Shift Pedal, making it difficult to SHIFT UP. (I had to bend the bar a bit.)
Adjusting the stop-lamp switch is also a pain.

If you are unsure or unconfident, we recommend that you have a contractor install it.
You can probably install it yourself if you try hard enough, but do so at your own risk.

I'm very happy with the Large variant of the Rear Sets.
Would be 5 stars if I hadn't replaced it myself! LOL!

The Change side is easy to replace, but while driving, the bar with the Spring on the Side Stand? is close to the Change Pedal. For now, I escaped with the most LargeBag&Up. It takes a long time to adjust the brake side stop-lamp light. It took half a day.

The product itself is very good, and the look (I bought the black one) and feel of the product when it's installed Good!
Installation on the GEAR side seems to go pretty easily
However, Brake Side was Large strange
It is also hard to adjust the sensitivity of Brake's Sensor
It's still pretty tough not to have an Installation Instruction Manual
You can replace the Handlebar by yourself If you are a Level person who says "I can replace the Handlebar by myself", you should not do DIY For those who want to challenge it by yourself, I think there is a sense of satisfaction after attaching it
I've driven about 200k miles since I installed it, and it's not like the footpegs don't hit my feet at traffic lights It was very good

We have a 30mm Lowdown and Short Stand, but
If you raise the STAND, the stick on which Spring is hooked will be very hard to change getting closer
I bent the part of the bar where the Spring of STAND is stuck because the toe wouldn't fit

Although there will be individual differences, it takes quite a lot of time to adjust the OEMSwitch of Brake Side

It was tough to be honest to take it out as I can not hold it.

We recommend that you ask Shop for those who are not good at installing.

Other than that Large satisfied

There is no Demerit after installation

I felt that footpeg does not hit the foot in the signal wait is such a good thing