Looks like you access from European region.
Would you shop at webike.eu.com?
115.52 USD (18,415 JPY)
Delivery Information
Out of stock at the manufacturer.
[Specification]
・Charging voltage: 14.5V-0.5
・Maximum input: 50A
Compatible conditions: Three-phase AC power generation (not available for field coil vehicles)
*
*Please do not install unless you are an experienced person who can judge the quality of the electrical components such as stator coil.
*If the ground wire on the vehicle side is defective, or if you use a battery made overseas, the charging voltage will not rise and the regulator will be damaged early.
*Please be sure to measure the charging voltage after installation.
*There may be changes in product specifications due to the manufacturer's reasons.
.
H.CRAFT original MOSFET regulator.
Coupler Harness Set.
It has the same performance as FH020.
It can be used with a wide range of batteries, from conventional open type batteries to lithium batteries.
The difference from the conventional regulator is that the heat generation is very small, and the stable charge voltage can be maintained from low to high rotation, and the maximum 14.4V can be controlled.
It can be used to stabilize the power supply of the vehicle and to increase the capacity of the stator coil.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Reviews with image
Oct 6, 2021
Wrecker moved with RegulatorPuncture. When I thought about getting a replacement regulator, this product that also comes with a coupler was a good deal. It was difficult to install, but it runs without a problem. I am expecting durability.
View DetailMar 18, 2020
I'm using a single-phase AC-powered motorcycle and I'm getting 14.6V at Idling
It was virtually unchanged when running and the body was only slightly warm However, it is single phase so it was missing one Dummy cap There are no instructions
Review detail
