Transferring from AK021
Installed on JA10CROSS CUB
Initially, I used AK021 in the winter, but it faded with age (7 years of use), and the Vinyl window cracked, etc.
I bought this product called New Model because I have a lot of gaps in my life.
Very easy to install, even for beginners Large sturdy!
There is an opinion that the Rib knit Caph of the place to put your hand is a hindrance, but I like it from the previous model and buy
There are no drafts and with the Grip heater you can commute to work warm even in freezing temperatures!
However, because it is a Universal Product, some processing is required.
In case of CUB, Axel side is OK without processing as it is.
If you install the Left Side as it is, your thumb will not be able to reach the area where the Switch is concentrated.
The hole for the Handlebar and the pouch for the thumb are too close together to reach the Switch.
I can get the Blinker to Right (press the Blinker switch to Right).
Because HornButton is pushed together when it thinks that it is going out to Left (Blinker switch is pulled to Left).
I can't pull the Switch to Left because it's too loud and annoying.
As a countermeasure, it was necessary to re-drill a new hole to pass the Handlebar through and to cover the original hole.
The problem is solved if you can modify the pouch to make room for the thumb.
This is not a dedicated product, so it will not be a just fit for all motorcycles.
It's a good product if you keep that in mind.
Looks like you access from European region.
Would you shop at webike.eu.com?
