Looks like you access from European region.
Would you shop at webike.eu.com?
Product # D-2149
2.5 (2 reviews)24.02 USD (3,829 JPY)
Delivery Information
This item is discontinued.
Switch can be fitted with two lights.
The switch is compatible with bike inspection with fog mark and indicator.
**This product is for Japanese DC12V bikes only.
*Some modification to the bike may be required for installation.
*There may be changes in product specifications due to the manufacturer's reasons.
*Delta Direct shall not be liable for any damage to this product or related parts caused by improper installation or handling of this product.
*If this product is not installed correctly, it may cause an accident such as disconnection during driving, etc. Installation and maintenance should be performed by a mechanic qualified in maintenance.
*If you feel any abnormality or abnormalities while driving, stop the bike immediately in a safe place and stop using it.
*Please refer to the manufacturer's service manual for your model of bike when installing the product.
*Vibration of the engine may loosen the bolts and nuts.Always check the tightness of each bolt and nut before riding.
*This product is intended for installation (switching relay harness) of Delta Direct products (D-1677, D-1378) fog lamp.Use of this product in conjunction with another company's product is at your own risk and is not covered by the warranty.
*When wiring, avoid high-temperature areas and be careful not to snag or pull on moving parts such as fans.
*When installing only one light, use vinyl tape to waterproof and insulate the terminal on one side that is not connected.
*The length of each wire is up to the relay unit.
*It is necessary to comply with Article 199 (front fog lights) of the public notice that prescribes the details of safety standards for road bikes.
.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Reviews with image
Feb 13, 2022
MOTO LED for Fog LampSwitch HarnessKit
The configuration of the product is large and good, but the crimp on the wiring terminal of the Relay and Fuse part is not good enough, and it came off during the wiring. I would like you to use a solder or something to prevent the wiring from coming loose.
View Detail
May 31, 2021
[How is it used?
Purchased for the installation of the company's Fog light and Moto LED.
Was the one you received as per Image?
It consists of Harness, Relay, Switch, and Bullet Type Terminal, as per Image.
How was your experience with it?
Since there are Sea Rings and Cable exteriors in the necessary places beforehand, it can be pimped out if you are not particular.
[Points to note]
There are three things that bothered me. I'm sure they are fine for use with the company's LEDs.
1. The input and control wires of the Relay are on the same wire, and the car Both Sides +− and fog +− 2 sets of 6 wires are on the Wiring end.
In the Instruction Manual, the car Both Sides + line is directly linked to the battery or Accessories, but the former does not link to the main key and the latter does not link to the battery.
With the latter, I didn't think Relay made much sense because of the load on the ACC power supply.
(I modified the Relay control line to connect to ACC)
2. Since the core wire of Wiring is about 0.2sq, please be careful to connect Lamp with high load.
3. The Bullet Type Terminal for the fog is crimped with Male and Female terminals on the + and +minus; sides.
+There is a risk of shorting between Body ground when the wire is disconnected. (I have replaced it.)
How did it compare to other products?
We saw very few fog harnesses for motorcycles from other companies, and the ones we did see were almost double the price of this product.
From the price, I thought that the above-mentioned notes might be acceptable, but please be careful when you divert it.
Review detail
