Looks like you access from European region.
Would you shop at webike.eu.com?
I purchased a Kawasaki Zr-7S to convert to Separate Handlebars.NORMAL is Handlebar Up Type, so if it is made into Separate Handlebars, it will surely hit the Tank.A Handlebar Stopper is required to co...Read More- [How is it used?I bought this bolt to prevent the cowl from interfering with the handlebar on my Ninja 400. The supplied bolt is not long enough so I bought a 55mm bolt and installed it.Was the instal...Read More
- I bought this for my TZM50 but I couldn't install it.It is a spec. that fits into the NORMAL Handlebar Stopper welded to the frame.The width of the groove is insufficient for the thickness of the Hand...Read More
- I use it because I'm afraid of getting my hand caught in the Handlebar.Read More
- I think this is a standard product of Handlebar Stopper.I use it on my NSRmini and KX65.Both of them can be installed without any processing.It is better to check it once in a while that the screw loo...Read More
- I bought it because I had to control the angle of cut due to a change in Stem.It was installed on a vehicle that was not listed in the fitment column, but there was no problem.Even the thickness of th...Read More
- My boss suggested I buy it, but I didn't even know such a product existed.Separate handle, so that the Handlebar hits the Tank. But now that I have this product, I don't have to worry about hitting th...Read More
- We are attaching to the first half of NSR 50.When exchanging with outside company's Separate handle, we installed Handlebar to interfere with Tank. Installation can take less than 5 minutes.I can ...Read More
- It is not for RZ 250, but it was possible to install. Some processing is necessary. We scraped out and spread in the place to enter with File, Bolt alone stops with Body's Receptacle screw but it ...Read More
- It is attached to NSR 50.When you install external Cowl etc., it may be caught between Cowl and Handlebar when you turn off Handlebar.In the worst case, I heard that you cut your finger and cut it.Als...Read More
- This time purchase for making XJR 1200 Separate handle.It is unnecessary for HURRICANE and others, but for Separate handle other than HURRICANE it is essential as it corresponds to Tank.Although Stopp...Read More
- [a Webike Monitor] -- > -- The Screw which becomes tight to where ... -- although it stops where and does not understand whether it is at the time -- it is a Stop about a bundle by suitable power deg...Read More
- If there is this, of course, as for a radiator, a tank will be protected in the case of a fall.Read More
- Since XT tank was again put on TW, it purchases. Since it does not suit, the character portion of KO is expanded to the size of TW a little with a file etc. the rubber board was fixed with pate until ...Read More
- It was used when making a zephyr 1100 into a separate handle. It was called this and has been used as it is, without also processing it. Since it can do without processing a frame and a handle stopper...Read More
- A thing called this handle stopper makes the piece angle of a handle somewhat small so that a finger may not be pinched between a tank and a handle at the time of a fall. Since attachment is easy, the...Read More
?
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING