Looks like you access from European region.
Would you shop at webike.eu.com?
- I installed a LEDICRelay made by MOTO LED and the Blinker did not respond.The other day, when I installed DRC's LED Fender Eliminator Kit, KITACO's Unbreakable lensMini Blinker on the front and rear o...Read More
- I bought this to use on my WR250F, but I didn't read the instructions carefully and ended up not being able to use it ……It's a product I didn't have to buy because it worked fine without this ICRelay ...Read More
- I also write other people, but I can not even pinpoint Wiring because it is difficult to understand.I stopped it with Tie Wrap at the place where I removed the original Relay.Also, it does not have an...Read More
Since the purchase attachment itself only attaches a terminal in order to exchange for an LED Blinker, just Colet of an easy free D-TRACKER is insufficient, and since it becomes a Hazard, a Harness i...Read More- The Blinker relay purchased at the daily Sale.
That (it falls into a High-flasher phenomenon) which cannot use a pure relay by change of resistance when it changes into an LED Blinker from the Blinke...Read More - It purchased with the formation of Blinker LED of WR250X.
Since DRC relay is a three-wire system and the connection portion of WR250X is a 2-wire system, it does not go with a Coupler on.
Wiring con...Read More - It is difficult even if it calls it evaluation of IC relay.
Since it is not the specialist.
(Smile) It is IC relay well.
There is a slot of a Cable-tie stop in the center, and the Cable tie is att...Read More - It exchanges according to the blinker of MOTOLED. Completely with [ an operation ] no problem naturally.Read More
- It is used for LED-izing of KLX. Since he was poor at wiring, I got the contractor to attach it. Attachment is the almost same part as Mr. T-NOBY.Read More
- It purchases for the D tiger X and LED-izing. Attachment is under a sheet. The pure relay was removed and it soldered to solderless contact by the side of a car body. The grounding terminal was insert...Read More
- He bought it by the blinker and set of DRC. Since it is components required for making it operate normally. It may be better for how to be able to connect by oneself and twist to leave it to Schopp, a...Read More
- Since its own motorcycle was a sherpa, the relay was in the location which cannot be attached unless it removes a tank. Since one cable tie was contained by attachment, pains did not need to be taken ...Read More
- Although it is the relay which is needed when attaching the LED blinker of a photograph, since it is a type which wiring is cut also here and connects it, it is not quite satisfactory. However, he did...Read More
- With the relay of three poles (a power source, a relay output, vehicle body grounding) used when making a lamplight system LED-ization, seemingly it attached to the off-road vehicle in many cases, and...Read More
- The relay on the Wright flesh side is removed to D tiger, and the bullet terminal terminal of the existing line and attachment ties to it as it is in a description. It waterproofs by a vinyl tape and ...Read More
?
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING